Recreational Fan Kit

Fogging is caused by POOR airflow inside the mask, hot air get trap between you and the lens. The body creates a lot of heat during paintball; that heat then gets trapped inside your mask causing the cooler lenses to fog and distort your vision. Our Fans work by circulating and refreshing the air between your face and the lenses. Cool air is push in or hot pull out (Depened on mode used). The cooler/fresher air on the inside of your lenses prevent fog from occurring. No need to withdraw from the filed due to extremely fog lens or ducking behind someone to lift your mask and wipe.

Been used in the tropical climate with excellent result. Down in the island the temperature can raise up to 88 C in the Jungle-type field and this fan kit have work excellently. No fog. Air movement mode that can be used are pulling air or pushing air from lens area..
Recommended set up is pulling air from mask, fan side with sticker at top (side up).
Fan is quiet (Bench test). But some user could hear some sound do to Mask accoustics.
Recommend use of good quality battery and as continuos fan.
Kit comes assembled. (fan to connector) but with everything needed to get fan attach to mask.

Kit include: ONE fan, 4 nylon ties (Not pictured), ON/OFF Switch and Battery connector (Batteries not included) .
Warrant to not be a DOA.
All kit tested prior to shipping.

All shpping done to USA and territories trough USPS will have tracking number. Tracking number supplied trough paypal account. 🙂 Exclude international destinations.





Disclaimer:
Kits are build and design to create an air flow within the mask itself. Intended to be assembled outside the eye compartment (Inside the lens). No modification should be done to the mask/goggle that will break the safe surrounding created in the mask eye area. This could predispose to eye injuries if any debris is created due to accidental breakage of fan or any part. Fan have moving parts, long air can get trapped inside the fan motor. Recommend using a hair-net to prevent hair getting trapped inside the fan motor.
The user assumes all responsibility from the use of this kit. The manufacturer or the seller can not be liable from any injury that could arise during activities were this kits been use.
By purchasing this kit, the user agrees to assume all responsibility from the use and safe handling. Kits are design to create an air flow within the mask. Intended to be assembled outside the eye compartment. No modification should be done to the mask/goggle that will break the safe surrounding created in the mask eye area (eye compartment).

Be Sociable, Share!

About the Author