D-Fan (Dual Fan) Kit – Paintball Mask Fan


Fogging is caused by POOR airflow inside the mask, hot air get trap between you and the lens. The body creates a lot of heat during the game; that heat then gets trapped inside your mask causing the cooler lenses to fog and distort your vision.

Our Fans work by circulating and refreshing the air between your face and the lenses. Hot humid air is pullout while Cool air is push in. The cooler/fresher air on the inside of your lenses prevent fog from occurring. The fan recommended set up is to use both fans pulling air from the mask.
No need to withdraw from the field due to extremely fog lens or ducking behind someone to lift your mask and wipe.

This is not the spray or the cream sell around here claiming to get rid of the fogging. That after you apply it, you hope that it work. This are the only real solution for the fogging problem in our sport. This kit been used in the island tropical climate with excellent result. Down here the temperature can raise up to 88 C in the Jungle-type field, with high humidity, and this fan kit have work excellently. Been used in the mode of both fans pulling air from the mask. Just awesome, No Fog

Fan Size: 25mm x 25mm Brushless fan.
– Housing / Blade Material: thermoplastic
– Ultra quiet MID speed brushless DC fan with sleeve-bearing design
– Kit Voltage: 10V
– Airflow: 5.8CFM / Each fan
– Life Expectancy: 40,000 hours

Kit comes disassembled (Soldering is required)
Kit include: Two fan, 6 Nylon Ties, ON/OFF SWITCH, And 9 volt Battery connector (Battery not included).
Warrant not a DOA (Dead On Arrivla). All kit components are QC tested with a constant energy source prior to shipment. If problem of kit running slow or stopping prematurely, check you battery packs (or change it for fresh quality one).

Recommended Set up: Pull air from the mask. Recommended position is similar to the picture, sticker side up. Button is splash resistant, not water resistant.

All shpping done to USA and territories trough USPS will have tracking number. Tracking number supplied trough paypal account. 🙂 Exclude international destinations.

Disclaimer:
Kits are build and design to create an air flow within the mask itself. Intended to be assembled outside the eye compartment (Inside the lens). No modification should be done to the mask/goggle that will break the safe surrounding created in the mask eye area. This could predispose to eye injuries if any debris is created due to accidental breakage of fan or any part. Fan have moving parts, long air can get trapped inside the fan motor. Recommend using a hair-net to prevent hair getting trapped inside the fan motor.
The user assumes all responsibility from the use of this kit. The manufacturer or the seller can not be liable from any injury that could arise during activities were this kits been use.
By purchasing this kit, the user agrees to assume all responsibility from the use and safe handling. Kits are design to create an air flow within the mask. Intended to be assembled outside the eye compartment. No modification should be done to the mask/goggle that will break the safe surrounding created in the mask eye area (eye compartment).

Be Sociable, Share!

About the Author